Raspberry Pi Dragino LoRa/GPS Hat + DS18B20 temperature sensor

Wanted to log the temperature with the LoRa gateway pi, but had to use another gpio since gpio4 was already in use for the Dragino LoRa/GPS Hat.

Just solder the DS18B20 sensor as in the image (the blue resistor is a 4k7 ohm pullup between data and +3v3).

And then add the following to /boot/config.txt

dtoverlay=w1-gpio,gpiopin=22

Reboot and you will find the sensor in /sys/bus/w1/devices/.


Leave a Reply

Your email address will not be published. Required fields are marked *